User Manual

FLYING YOUR 1SQ V-CAM

❏ Move the left stick to the lowest position and then turn the transmitter on.

Electric motors are very dangerous. Do not work on the

model while the flight battery is plugged in as interference

may cause the main rotor blades to spin, possibly causing

injury to yourself.

❏ Install the flight battery by sliding

the battery into the bottom of the quad.

Make sure the battery is slid all the way

to the stop of the battery tray. Connect

the battery to the connector.

NOTE: The quad will be “ON” at this

point. Place the quad on a flat surface

for 2 seconds to calibrate the TAGS-FX.

Your quadcopter has a safe start

feature built in that prevents the motors from activating unless the throttle

stick has been lowered to the lowest position. If the motors won’t run and

turn the blades, please make sure the throttle stick is all the way down and

leave it there for a couple of seconds. Then try moving the stick up slowly.

Takeoff

If flying outdoors it’s important to stick to light winds. If you are taking off

and landing in grass, place a rubber mat or pad down on the grass so the

small rotating parts don’t get hung up in the grass.