User Manual

Charging and Operation Warnings

● Only use the included charger with the included LiPo battery.

Do not attempt to use the provided charger with NiCd, NiMH

or batteries with other chemistries.

● Do not leave the charger unattended while in use and always charge your

battery in a ﬁ re-resistant location.

● Disconnect the battery and remove input power from the charger immediately

if either becomes hot!

● Do not allow water or other foreign objects to enter the charger. Keep the

charger away from moisture and do not submerge in water.

● Please keep all electronic components out of the reach of children!

● WARNING!! The charger supplied with the Heli-Max 1SQ Quadcopter

contains protective circuitry. If you experience any difficulties while charging

the battery, please disconnect the battery from the charger and unplug

the charger from the power source. Allow the battery and charger to rest

for two hours as this will allow the charge protection circuit to reset. If this

issue re-occurs during normal use, please contact technical support for

further assistance.

CHARGE THE FLIGHT BATTERY

❏ Plug the flight battery into the end

of the USB charger.

❏ Plug charger into a USB port. A

steady red light will glow letting you

know the battery is charging. The light

will flash slowly when the charge is

complete. Remove the battery from

the charger. Under normal operating

conditions, the battery may take up to

60 minutes to recharge. Never leave

the battery attached to the charger

after charging is complete.

NOTE: A fast flash indicates a charge error. This is usually an indication that

your battery is defective and should be replaced.