Operating Instructions

Operation Instructions
The following is the operational instruction for your IPLink1200.
1) Install the IPLink on your board
2) Using your installation CD, install the Helicomm IP-Software into your
computer.
3) Apply power to your module.
4) Via your interface cable connect the IPLink to the computer.
5) Down load the firmware into your module.
“ This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.”