Operating Instructions

Operation Instructions

The following is the operational instruction for your IPLink1220.

1) Install the IPLink on your board

2) Using your installation CD, install the Helicomm IP-Software into your computer.

3) Apply power to your module.

4) Via your interface cable connect the IPLink to the computer.

5) Down load the firmware into your module.

“ This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause

undesired operation.”

6) Label your device with “Contains FCC ID: RF2IPLINKP220”

CAUTION:

The user is cautioned not to modify or change the IPLink1200 without explicit approval

from Helicomm. If the user does not comply, authority to operate the equipment will be

void.

PAGE 1
Operation Instructions The following is the operational instruction for your IPLink1220. 1) Install the IPLink on your board 2) Using your installation CD, install the Helicomm IP-Software into your computer. 3) Apply power to your module. 4) Via your interface cable connect the IPLink to the computer. 5) Down load the firmware into your module. “ This device complies with Part 15 of the FCC Rules.
PAGE 2
INFORMATION TO USER This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to Part 15 of the FCC Rules.