User Manual Buggy 1-10 Conquest 10B XB 2WD

QUICK-START GUIDE
Full manual available to download from: www.Helion-RC.comFull manual available to download from: www.Helion-RC.com
1
Remove the components from
the box and ensure the contents
are correct:
• 1 x Conquest 2WD Buggy
• 1 x 2000mAh 6-cell NiMH
battery pack
• 1 x IKONNIK ET3 2.4GHz
3-channel transmitter
• 1 x 6-cell wall charger
• 1 x Quick-Start Guide.
2
Remove the two body clips from
the car and lift the body clear.
3
Locate the battery cradle in the
centre of the car, release the hook
and loop tape and withdraw the
battery pack.
4
Plug the charger into a wall
socket, connect the battery to the
charger and place the battery on
a non-ammable surface. Switch
the wall socket ON noting that
a fully discharged battery will
be charged in approximately 3
hours. Periodically monitor the
temperature of the battery when
charging and disconnect if it
exceeds 120°F (49°C). Unplug
the battery when charged.