HLNB0020 Helion Rivos Manual

6
Preparing your Boat
Slideyourfullychargeddrivebaeryintothe
hull and strap in place with the hook and loop
fasteners.
Placethetophatchinposionandrotatethe
latch to secure.
Withyourtransmierturnedon,plugthe
drivebaeryintothespeedcontrol.
Important
Do not arm the boat motor unl you have
placed the boat into the water.
Once in the water, arm the motor by
pushing the throle trigger forward and
then pulling it to the rear.
Binding
Insert
Bind Plug
Transmitter Bind Button
Press and Hold
The Rivos comes already bound. If however you need to
re-bindfollowtheseinstrucons.
WiththetransmierswitchedOFF
Plug in the bind jumper plug (included in your spare
parts bag) into the CH3/Bind Slot on the Receiver. Plug
thebaeryintotheelectronicspeedcontrol(ESC)The
redLEDonthereceiverwillblinkrapidlyindicangthatit
is in bind mode.
Pressandholdthebindbuononthetransmierwhile
sliding the power switch ON.
Releasethebuonaerthetransmierpowersup.The
transmierwillmakeabeepingsoundtoindicatethatit
isinbindmodeWithinapproximately5secondstheRivos
willlinkandtherudderwillcenterandLEDwillgosolid.
Remove the bind plug from the reciever. You are ready to run.