Owner's Manual

Hünegräben 26 · 57392 Schmallenberg · Germany · Tel.: [phone] · E-mail: contact@audiotec-scher.com
6. Make sure that the module is installed properly and all pins are
fully inserted into the socket:
7. If the bottom plate was bolted, x the new side panel which is
delivered with the Extension Card. Afterwards reinsert the bottom
plateandxit,too.Otherwisereinsertthebottomplateatrstand
thenxthenewsidepanelwiththescrews.
8. Reconnect the power supply and ground cable to the device.
9. Connect the amplier / DSP to your computer. If you have to
bridge longer distances please use an active USB extension
cable with integrated repeater or the optionally available WIFI
CONTROL interface.
10. First turn on the device and then start the latest software or at
least software version 4.61a. The Extension Card is automatically
detected.
11. IMPORTANT: After you have made the rough adjustment of the
input sensitivity and input load (see point 3), the input sensitivity
has to be ne adjusted in the DCM menu of the DSP PC-Tool
software. To do so follow the subsequent steps:
1. Open the “Extended Features” tab of the DCM menu.
 2.Select the congured Input Sensitivity Switch Position
position of your module.
3. Adjust the input sensitivity to match the output voltage of the
connected signal source.
12. Reconnect all remaining cables to the device.
Make sure that the polarity is correct. If one or more connections
havereversedpolarityitmaya󰀨ecttheperformanceofthedevice.
Important: It is strictly forbidden to use the modules highlevel
and lowlevel line input of an individual channel at the same time
as this may cause severe damage to your head unit / car radio.
Nevertheless it is possible to use the highlevel input of one chan-
nel and the lowlevel line input of another channel simultaneously.
Attention: Solely use the connection cable with the 4-pole con-
nector and open leads, which is included in delivery, to connect a
signal source to the highlevel inputs of the module!
For the connection of the 3.5 mm stereo line input we recommend
to use a shielded 3.5 mm jack cable to avoid any background
noises.
Signal routing of the Extension Card
NowtheinputscanbefreelyconguredasadditionalMAINInputsor
as an AUX source. To do so route the “AUX L” and “AUX R” signals
whether in the “Main Routing” tab or in the “AUX / HEC Routing” tab.
The “Used Input” window indicates automatically which input is con-
nected and in case of the highlevel input it also indicates the position
oftheLoadJumper.Theusedinputhasinuenceoftheadjustable
rangeofthe“InputGain”conguration.
Warranty disclaimer
The limited warranty comply with legal regulations. Failures
or damages caused by overload or improp er use are not
covered by the warranty. Please return the defective product
only with a valid proof of purchase and a detailed malfunction
description. Technical specications are subject to change!
Errors are reserved!
For damages on the vehicle and the device, caused
by hand ling errors of the module, we can’t assume
liability. These devices are certied for the use
in vehicles within the European Community (EC).
EXTENSION CARD
HEC / MEC ANALOG IN