Owners manual

INSTALLATION INSTRUCTIONS

1-1/8” FRONT STABILIZER BAR

1967-70 FORD MUSTANG Small & Big BlockApplications

Thank you for purchasing a quality Hellwig Product.

PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION

6707 ( R-6707) 07/09/04

TORQUE TABLE

BOLT SIZE: 3/8” = 20-30 ft. lbs. – 7/16” = 35-45 ft. lbs. – ½” = 50-70 ft. lbs. – 9/16” = 70-90 ft. lbs.

SAFETY: BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND CHOCK

TIRES.

NOTE: TO EASE INSTALLATION AND TO PROPERLY ADJUST THE BAR, THE WEIGHT OF THE VEHICLE

MUST BE ON THE SUSPENSION, AS IF DRIVING DOWN THE ROAD.

DO NOT RAISE VEHICLE BY THE FRAME.

NOTE: THIS SWAY BAR IS DESIGNED TO REPLACE THE FACTORY MOUNTED SWAY BAR OR AS A

REPLACEMENT IF THE VEHICLE IS NOT EQUIPPED WITH A FRONT SWAY BAR.

559-734-7451 800-367-5480 FAX 559-734-7460

PAGE 1
559-734-7451 800-367-5480 FAX 559-734-7460 INSTALLATION INSTRUCTIONS 1-1/8” FRONT STABILIZER BAR 1967-70 FORD MUSTANG Small & Big Block Applications Thank you for purchasing a quality Hellwig Product. PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION 1 1 TORQUE TABLE BOLT SIZE: 3/8” = 20-30 ft. lbs. – 7/16” = 35-45 ft. lbs. – ½” = 50-70 ft. lbs. – 9/16” = 70-90 ft. lbs. SAFETY: BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND CHOCK TIRES.
PAGE 2
559-734-7451 800-367-5480 FAX 559-734-7460 1. Remove the factory mounted front sway bar. 2. Install the D-shaped poly bushings on the sway bar in the position that they will make contact with the mounting bracket on the vehicles frame. 3. Raise the sway bar up to the frame using the supplied U-plates and the mounting hardware. Start the mounting bolts but do not tighten - leave loose at this time to allow for adjustment later. 4. Assemble the end link assemblies as per PHOTO TWO (2).