Owner's manual

INSTALLATION INSTRUCTIONS

Adjustable Rear Stabilizer Bar

Ford F-250/F-350

Thank you for purchasing a quality Hellwig Product.

PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION

1 2

559-734-7451 800-367-5480 FAX 559-734-7460

7282( R-7282) 10/30/2012

PAGE 1
559-734-7451 800-367-5480 FAX 559-734-7460 INSTALLATION INSTRUCTIONS Adjustable Rear Stabilizer Bar Ford F-250/F-350 Thank you for purchasing a quality Hellwig Product.
PAGE 2
559-734-7451 800-367-5480 FAX 559-734-7460 TORQUE TABLE BOLT SIZE: 3/8” = 20-30 ft. lbs. – 7/16” = 35-45 ft. lbs. – ½” = 50-70 ft. lbs. – 9/16” = 70-90 ft. lbs. SAFETY: BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND CHOCK THE WHEELS. NOTE: TO EASE INSTALLATION AND TO PROPERLY ADJUST BAR, THE WEIGHT OF THE VEHICLE MUST BE ON THE SUSPENSION, AS IF DRIVING DOWN THE ROAD. DO NOT RAISE THE VEHICLE BY FRAME.
PAGE 3
559-734-7451 800-367-5480 FAX 559-734-7460 6. Attach the end links to the frame rail as shown in Photo 5 using the 1/2 X 3” bolt, washers and locknut. 7. Center sway bar on the differential. Be sure to move any lines, wires or hoses on the axle or the inside of the frame to avoid any damage. Rotate bar up and down to make sure there is adequate clearance to all axle and undercarriage components as the suspension articulates.