Manual

7698 (R-7698) 10/12/2007
TORQUE TABLE
Bolt Size 3/8”— 35 ft lbs * Bolt Size 7/16”— 45 ft lbs* Bolt Size 1/2”—75 ft lbs *Bolt Size 9/16”— 90 ft lbs
SAFETY: BEFORE BEGINNING INSTALLATION BE SURE TO SET THE PARKING BRAKE
AND CHOCK THE WHEELS.
NOTE: TO EASE INSTALLATION AND PROPERLY ADJUST THE BAR, THE WEIGHT OF THE
VEHICLE MUST BE ON THE SUSPENSION AS IF DRIVING DOWN THE ROAD. DO NOT RAISE
THE VEHICLE BY THE FRAME.
NOTE: THIS UNIT IS DESIGNED TO MOUNT TO THE BOTTOM OF THE AXLE TUBES WITH
THE ARMS OF THE BAR TOWARD THE REAR OF THE VEHICLE.
1. Lubricate the D shaped bushings and place them on the straight areas of the bar on each side of
the center hump.
2. Hold bar up to the axle and locate the position on the axle tubes to mount the u-bolts. Be sure to
put the U-Bolts Under Any Brake Lines, Wires or Hoses on the Axle to Avoid Any Possible
Damage. The threads of the U-Bolts will point down.
3. Install saddles on axle so that they sit squarely on the axle. Place the spacer plates on top of the
saddles. Place the U-Plates over the D shaped bushings on the bar and attach the bar to the U-
Bolts and saddle brackets with the flat washers and nuts provided. LEAVE LOOSE AT THIS
TIME to allow for adjustment later.
4. For additional bar clearance remove the driver side lower shock bolt, turn it around and reinstall
from the outboard side of the lower shock bracket.
INSTALLATION INSTRUCTIONS
Rear Stabilizer Bar 7698
2007.5+ GM 2500HD-3500HD 2WD-4WD
6.0 Gas Applications Only
Thank you for purchasing a quality Hellwig Product.
559-734-7451 800-367-5480 FAX [phone]