User Manual

7719 (R-7719) 12/21/2011

SAFETY: BEFORE BEGINNING INSTALLATION BE SURE TO SET THE PARKING BRAKE

AND CHOCK THE WHEELS.

NOTE: TO EASE INSTALLATION AND PROPERLY ADJUST THE BAR, THE WEIGHT OF THE

VEHICLE MUST BE ON THE SUSPENSION AS IF DRIVING DOWN THE ROAD. DO NOT RAISE

THE VEHICLE BY THE FRAME.

INSTALLATION INSTRUCTIONS

Front Stabilizer Bar 7719

2005+ Toyota Tacoma

Thank you for purchasing a quality Hellwig Product.

PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION

559-734-7451 800-367-5480 FAX 559-734-7460

PAGE 1
559-734-7451 800-367-5480 FAX 559-734-7460 INSTALLATION INSTRUCTIONS Front Stabilizer Bar 7719 2005+ Toyota Tacoma Thank you for purchasing a quality Hellwig Product. PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION 1 SAFETY: BEFORE BEGINNING INSTALLATION BE SURE TO SET THE PARKING BRAKE AND CHOCK THE WHEELS. NOTE: TO EASE INSTALLATION AND PROPERLY ADJUST THE BAR, THE WEIGHT OF THE VEHICLE MUST BE ON THE SUSPENSION AS IF DRIVING DOWN THE ROAD.
PAGE 2
559-734-7451 800-367-5480 FAX 559-734-7460 Subframe Supports 2 3 1. Unbolt and remove the factory splash guard shown in PHOTO 2, making sure to save all the components to reinstall. 2. Unbolt and remove the two factory subframe supports shown in PHOTO 3, making sure to save all the components to reinstall as well. 3. Unbolt the factory sway bar, leaving the end link on the vehicle. Once again, retain all the hardware for the installation. 4.
PAGE 3
559-734-7451 800-367-5480 FAX 559-734-7460 6 12. After all adjustments have been made, tighten the collar clamp bolts to 5-8 ft-lbs and the other bolts to factory specifications. 13. Reinstall both the factory subframe supports and factory splash guard. 14. Bounce the vehicle checking for clearance on all under carriage components: fuel tank, shocks, exhaust, differential, brake and fuel lines, etc. Test drive the vehicle and recheck all clearances and the installation alignment. Adjust as needed.