Manual

ManualsBrandsHellwig ManualsFor the carSway Bar 7870

INSTALLATION INSTRUCTIONS

1997-2006 Jeep Wrangler TJ

(Coil Sprung Front Suspension)

7870 FRONT STABILIZER BAR

Thank you for purchasing a quality Hellwig Product.

PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION

7870 ( R-7870 ) 8/3/2011

Plastic Cover

559-734-7451 800-367-5480 FAX 559-734-7460

U-Plate

D Bushing

Collar

Summary of content (4 pages)

PAGE 1
559-734-7451 800-367-5480 FAX 559-734-7460 INSTALLATION INSTRUCTIONS 1997-2006 Jeep Wrangler TJ (Coil Sprung Front Suspension) 7870 FRONT STABILIZER BAR Thank you for purchasing a quality Hellwig Product.
PAGE 2
559-734-7451 800-367-5480 FAX 559-734-7460 SAFETY: BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND CHOCK TIRES. NOTE: TO EASE INSTALLATION AND TO PROPERLY ADJUST THE BAR, THE WEIGHT OF THE VEHICLE MUST BE ON THE SUSPENSION, AS IF DRIVING DOWN THE ROAD. DO NOT RAISE VEHICLE BY THE FRAME. NOTE: THIS SWAY BAR IS DESIGNED TO MOUNT ON THE TOP OF THE WITH THE ARMS TOWARDS THE BACK OF THE VEHICLE.
PAGE 3
559-734-7451 800-367-5480 FAX 559-734-7460 Linch Pin 6 6. Loosely attach the rod end to the middle hole on the sway using the 7/16” bolt, washers and stover nut. The middle hole position is for sizing the end link only, it is recommended to start with the end link attached to the outermost (softest) hole until the driver gets used to the change in ride characteristic and they can then adjust the hole positioning for their driving style. 7.
PAGE 4
559-734-7451 800-367-5480 FAX 559-734-7460 Passenger Side Driver Side Existing Bracket Flat Washer Flat Washer Stover Nut 9 10 Stover Nut 11. On the inside of each D Bushing, place the collar to prevent lateral movement and tighten the allen head screws to 7-8 ft-lbs. See Photo 3. 12. Replace the plastic cover over frame bushings. 13. Connect the end link quick disconnect pins to the fender mounting brackets as shown in photo 8.