User Manual
Table Of Contents
20 MMS
®
Inspection SPG High
Settings for measurement
5.2 Creating a new batch
Each batch contains some presets for the measurement procedure.
The preset selection is based on the requirements in a directive/standard or
according to customer specifications.
Before you start
• The gage is switched on ( key)
Creating a new batch
1. Main Menu (V) > Batches > OK > New > OK
2. Measurements in air: Hold the device in your hand and press OK
This completes the creation process for a new batch.
What you can do next
• Measure, see Page 22
• Repeat calibration, recalibration, see page 24
• Make batch settings under Main Menu (V) > Batch Modify > OK
• Rename the batch, see page 35