User Manual

MMS
®
Inspection DFT
Gage type High
Instruments for coating thickness measurements
On our home page www.helmut-fischer.com you will find the addresses of our
sole agencies and subsidiary companies around the globe.
© 2019 by Helmut Fischer GmbH Institut für Elektronik und Messtechnik, Ger-
many.
This document is protected by copyright. All rights reserved. This document
may not be reproduced by any means (print, photocopy, microfilm or any oth-
er method) in full or in part, or processed, multiplied or distributed to third par-
ties by electronic means without the written consent of Helmut Fischer GmbH
Institut für Elektronik und Messtechnik.
Subject to correction and technical changes.
MMS® is a registered trade mark of the Helmut Fischer GmbH Institut für Elek-
tronik und Messtechnik in Germany and other countries.
Note: Designations not marked with ® or ™ may also be protected by law.
Document no. 902-624
Issue date 2019-09-09 (for software version 1.0.0+3)
Manufacturer
Helmut Fischer GmbH Phone: [phone] - 0
Institut für Elektronik und Messtechnik Fax: [phone] - 710
Industriestraße 21 www.helmut-fischer.com
D-71069 Sindelfingen [e-mail]
Quality Assurance System of the Helmut Fischer GmbH
DIN EN ISO/IEC 17025 Calibration lab accredited for certified mass per
unit area standards
DIN EN ISO 9001:2015 Management system certified by Swiss Associa-
tion for Quality and Management Systems (SQS)