User Manual

MMS
®
Inspection DFT High 23
Measurement
6 Measurement
During the measurement you can also:
• Delete single readings: Press the key
• View the statistics of the open measurement block: Press the BLOCK key
6.1 Notes on coating thickness measurement
Essentially: If the specified precision is not achieved during the measure-
ment, you must recalibrate the probe, see page 25.
Measured readings outside the specified tolerance limits are displayed in
red and indicated by an illuminated red LED.
The gage vibrates during measurement acquisition if this is activated in the
gage settings.
6.2 Before you start
• The gage is switched on ( key)
• The desired batch is opened ( key in the main menu, see also
page 21)