Quick Installation Guide

Document

WERA4-Quick-US-200918

Page 68 of 73

This option may be useful if you got an unstable router or modem for the network

connection, which needs to be reset automatically to dial into the internet again.

Please activate the checkbox at the top, if you want to use this option, and make sure

the correct port is defined.

This modem test will be executed together with the automatic system test.

To manually test the internet connection, please click on the corresponding “TEST”

button.

Make sure that no hardware is connected to the selected ports, which should not be

switched off.

Further note that the PSR in the WERA IV FCR or later do not have got the optional

“Digital Out” and “Aux2” outputs.

Figure: 5 setup window – Modem tab

If you finished configuring the software, click on “save” to save your settings or on

“save and close” to close the setup window. If you want to discard your changes, then

click on “close setup”.

7.10.1.6 WERA Setup-Window – Warnings tab

In the Warnings section of the setup window the automatic generation of warning and

status messages for the WERA warning system can be configured.