Installation Guide

SUGGESTED TOOLS AND MATERIALS
Adjustable Wrench Channel Lock Tape Measure Safety Glasses
INSTALLATION INSTRUCTIONS
TEMPERED GLASS
VESSEL SINK
(ALL MODELS)
10'
YOUR GLASS VESSEL SINK
BEFORE YOU BEGIN
Observe all local plumbing and building codes.
Follow these instructions only if it apply to your installation. Vessel sinks allow you to be creative and flexible with your installation
These instructions contain important care and cleaning instructions. Please review these instructions carefully.
Before installation, remove your new glass sink and carefully inspect it for damage. Return the glass sink to its packaging until you are
ready to install it
All vessel sinks do not have an overflow and may require a specific type of drain such as a pop-up, twist and turn or a grid drain
assembly. Please check your local plumbing codes to determine which drain will meet local plumbing code standards for this product.
STEP 1
Cut out a 1 3/4” hole on the counter-top for the drain. Please refer to
the cutout template.
Note: to avoid possible damage to the cabinet, cut the counter-top
before installing the counter-top to the cabinet.
CARE INSTRUCTIONS
For best results in caring your glass sink, we suggest:
Never use strong / abrasive cleaner. Always test your cleaning solution on unnoticeable area before applying to the entire surface.
Wipe surfaces clean, immediately after applying cleaner.
Do not allow cleaner to sit or soak. Never let cleaners sit on the surface of the glass.
Use a soft, dampened sponge and cloth. Never use an abrasive material such as brush or scouring pad to clean surfaces.
They will scratch the glass surface.
Always rinse and wipe clean the fixtures to prevent soap buildup.
STEP 2
Carefully, position the sink so that the drain hole and install the drain according
to the manufacturer’s instructions / manual.
STEP 4
Slide (a) rubber gasket to the top of drain body as shown.
STEP 3
Unscrew drain body from tail peice
Place mounting ring in the center of vessel top where it will align with cutout.
IF drain kit is supplied with the glass sink, follow these instructions.
STEP 5
Install drain body through sink.
From under countertop, screw on tail peice to drain body.
STEP 6
STEP 7
Slide (b) rubber mac washer to the drain body. Then screw (c) retaining nut to
the drain body.
STEP 8
Tighten the drain assembly lock nut by hand until it stops turning, making sure
that all silicone gaskets are used and in their proper places. Then turn the lock
nut ahlf turn with a wrench for final tightening.
It may be necessary to cut part of the tail-piece or part of the horizontal leg
in order to make fit to existing plumbing.
STEP 9:
Install the faucet according to the manufacturer’s instructions/manual.
CAUTION! Do not overtighten drain assembly as this
may cause bowl to forcefully crack during installation
or at some time in future.
Rev 3/2014
drain body
(a) rubber gasket
(b) rubber mac
washer
(c) retaining nut
mounting ring
tail peice