User's Manual

3.12 Set Alert Test
If no valid alarm signal is received within 10 days, the machine will beep every ten minutes to remind the user to
check the machine. Users can set the function ON or OFF.
1. Press Menu to open menu options.
2. Press ∧ or ∨ button to scroll through menu to TEST ALARM, then press SELECT
3. Press ∧ or ∨ button to the desired mode between On and Off
4. Press MENU or OK button to exit the setting.
Troubleshooting
Problem Suggestion
No Power
No Signal
Reception is Not Good
No Clock Alarm
No Sound
Make sure the power adapter is securely plugged into the back
of the weather radio and into the wall outlet.
Make sure batteries are installed in case of a power failure.
Make sure the antenna is in good condition or use external
antenna to improve reception
The radio is not responding properly to
weather alert broadcasts
Check VOLUME control to ensure volume is turned up to an
audible level.
Change to an open area
Make Sure set the correct channel
Make Sure the NOAA Switch to ON
Make sure the clock alarm setting is ON
No Voice Alert
Make sure the Voice Alert type is chosen
Make sure the clone cable works
No Beep While Pressing Buttons
Can not clone data
Make sure you have turned on the button beep
Make sure the master radio enter the correct menu
mode
Make sure that you have programmed in the correct country
code
Make sure that you have turned on the even alert
Frequency Correspondence Table
Channel Frequency(MHz)
1
2
3
4
5
6
7
162.400
162.425
162.450
162.475
162.500
162.525
162.550
Specifications
Frequency Range
Number of Channels
Output Power
Receiving Sensitivity
Working Voltage
Working Current
Standby Current
Power Supply
162.400~162.550MHz
1CH~7CH
3W
-120DBm
DC 5V
About 400mA
50mA
DC 5V & 3 X AA Alkaline Battery
05