User Guide

Docking Issues – Only Henge Docks or Apple brand Thunderbolt
cables may be installed into the docking station. Installing third
party cables into the dock will cause port binding and may result in
damage to the MacBook. If the MacBook is not docking properly,
perform the Port Reinstall procedure detailed below.
Port Reinstall - With screw cover
pulled back, loosen set screws and
remove all cables from the docking
station. While seated, place MacBook
into the empty dock, and  ip them
over as one unit, holding it in your lap.
Reinstall each cable individually,
through the corresponding port voids
and into the MacBook. Slide the cables
into the cable organizer at the back
of the docking station. Carefully  ip
the computer over, placing unit on a
 at, stable surface. With all cables in
place, tighten the setscrews, realign
the screw cover, and secure the
cover anchor. Reconnect peripherals
to cables.
If still experiencing difficulties,
contact our customer support
team at [e-mail].
perform the
procedure detailed below.
Port Reinstall -
With
screw cover
pulled back, loosen set screws and
remove all cables from the docking
station. While seated, place MacBook
into the empty dock, and  ip them
over as one unit, holding it in your lap.
Reinstall each cable individually,
through the corresponding port voids
and into the MacBook. Slide the cables
into the
cable organizer
at the back
of the docking station. Carefully  ip
the computer over, placing unit on a
 at, stable surface. With all cables in
place, tighten the setscrews, realign
the
screw cover
, and secure the
cover anchor
. Reconnect peripherals
to cables.
If still experiencing difficulties,
contact our customer support
team at
[e-mail]
.