Henkel, Inc. P.O. Box 1322 Hammond, LA 70404 (985) 345-2171 www.keenovens.
Henkel, Inc. P.O. Box 1322 * Hammond, Louisiana * 70404 * (985) 345-2171 www.keenovens.com Model K-50 Portable Oven Installation Instructions & Repair Parts List One Year Limited Warranty Henkel, Inc. warrants its products against defects in material and workmanship. Henkel, Inc.
Keen Ovens Model K-50 Specifications Electrode Capacity 50lbs. 18" rods Volts (Specifiy) 120V or 240V AC/DC Current Draw 1.25 amps Watts 150W Thermostat Factory Preset/Field Adjustable Temperature Preset 275ºF : Range 100ºF-300ºF Insulation 1" Interior Dimensions 6" X 6 X 19" H Net Weight 20lbs. Shipping Weight 21lbs. Shipping Dimensions 10.5" X 9" X 22.75" Safety Precautions Read all instructions completely before attempting to operate this unit.
• • Do not operate this unit empty. When using the unit at a distance where an extension cord becomes necessary, a 3-conductor grounding cord of adequate size must be used for safety, and to prevent loss of power and overheating. Use only a UL listed extension cord suitable for outdoor use. Make certain wire size is large enough for A/C amperage rating of unit. Operation To load oven, open latch on lid and simply place desired amount of electrodes in oven. The oven capacity is 50 lbs. of 18” electrodes.
4. Remove the two leads from thermostat terminals and check for continuity across terminals. If continuity is not present between thermostat terminals, replace thermostat. (See “Corrective Maintenance” section.) 5. If thermostat is good, check continuity of element. If continuity is not present, replace element. IF OVEN OVERHEATS 1. If oven overheats, adjust thermostat. (See “Temperature Setting” section.) 2. If thermostat calibration fails to lower temperature, replace thermostat.
THERMOSTAT CALIBRATION & ADJUSTMENT 1. Follow instruction numbers 1, 2, and 3 from Changing the Thermostat. 2. Thermostat is readily visible in bottom of oven. Use small screwdriver and turn set screw. (Turning set screw clockwise decreases temperature. Turning set screw counter-clockwise increases temperature. One-fourth [1/4] turn equals approximately 35ºF.) 3. Replace insulation and bottom of oven.
K-50 ACCESSORIES LIST ** Please state model number and serial number and specify voltage and wattage when ordering repair parts, spare parts, or accessory parts. All necessary attaching hardware is supplied with each part ordered. (Item numbers refer to pictorial drawings below for repair parts.
HENKEL, INC. Phone (985) 345-2171 Fax (985) 345-5653 PO Box 1322 Hammond, Louisiana 70401 Manufacturer of KEEN Ovens Quality Since 1923.