Corp. Fryer User Manual

Prior to servicing the solenoid valve, it is necessary to
remove the side panel on the right side of the unit.
1. Remove the “tru-arc” retaining clip on top of the coil
housing.
2. Remove the cover.
3. If only the coil is to be replaced, disconnect the two coil
wires at the wire nuts in the coil housing. Remove the coil,
insert new coil, and connect the wires at the wire nuts.
Assemble in reverse order of disassembly.
The wires may be connected in any order.
4. Loosen the screws on the strain relief and pull the wires
through the relief.
5. If the core-disc assembly is sticking due to build up of
shortening, breading, and food particles, proceed with the
following steps:
a. Unscrew the solenoid bonnet assembly from the
solenoid valve body.
b. Remove the solenoid bonnet assembly and bonnet
gasket.
c. Remove the core-disc assembly, core spring retainer,
and the core spring.
d. Wash all these parts in hot water.
If Teflon seals need to be replaced, proceed to Step 6;
otherwise, assemble in reverse order of disassembly.
Assemble valve core and blade with smooth side and
rounded edge of blade toward the disc spring guide.
6. A repair kit (Part No. 17120) is available if any of the seals
must be replaced. If any one seal is defective, they all
should be replaced.
Solenoid body, must be removed from the fryer for
replacement of seals.