Henny Penny Cold Bases Model CBC/CBR-103 Model CBC/CBR-104 Model CBC/CBR-105 Model CBC/CBR-106 Model CBC/CBR-107 OPERATOR’S MANUAL
Model CBC/CBR-103,104,105,106,107 LIMITED WARRANTY FOR HENNY PENNY APPLIANCES Subject to the following conditions, Henny Penny Corporation makes the following limited warranties to the original purchaser only for Henny Penny appliances and replacement parts: NEW EQUIPMENT: Any part of a new appliance, except lamps and fuses, which proves to be defective in material or workmanship within two (2) years from date of original installation, will be repaired or replaced without charge F.O.B.
Model CBC/CBR-103,104,105,106,107 TABLE OF CONTENTS Section Page Section 1. INTRODUCTION ................................................................................................................... 1-1 1-1. Henny Penny Cold Bases ............................................................................................ 1-1 1-2. Features ....................................................................................................................... 1-1 1-3. Proper Care ...................
Model CBC/CBR-103,104,105,106,107 SECTION 1. INTRODUCTION 1-1. COLD BASES The Henny Penny cold bases are self-serve units, designed to hold chilled, or refrigerated products. The units are electronically controlled for easy use and for consistent operation. 1-2.
Model CBC/CBR-103,104,105,106,107 1-5. SAFETY The Henny Penny cold bases have many safety features incorporated. However, the only way to ensure a safe operation is to fully understand the proper installation, operation, and maintenance procedures. The instructions in this manual have been prepared to aid you in learning the proper procedures. Where information is of particular importance or safety related, the words NOTICE, CAUTION, and WARNING, are used. Their usage is described below.
Model CBC/CBR-103,104,105,106,107 SECTION 2. INSTALLATION 2-1. INTRODUCTION This section provides the installation and unpacking instructions for the Henny Penny cold bases. Installation of this unit should be performed only by a qualified service technician. Do not puncture the unit with any objects such as drills or screws, or component damage or electrical shock could result. 2-2.
Model CBC/CBR-103,104,105,106,107 2-2. UNPACKING (Continued) Take care when moving the unit to prevent personal injury or damage to the refrigeration system. The units weigh between 400 (182 kg) and 580 lbs. (263 kg). 2-3. ELECTRICAL 4. Peel off any protective covering from exterior of the cabinet. 5. Install the grids into unit. 6. Your cold base is now ready for operation. The cold base is available as a 120 VAC, 60 Hz.
Model CBC/CBR-103,104,105,106,107 2-4. LOCATION Place the cold bases in an area where product can be loaded and unloaded without interruption. For proper operation, level the unit by adjusting the bolts under the base, and leave 3 feet (91.44 cm) clearance behind the unit for ventilation and service. For maximum efficiency, units should be operated in an air-conditioned environment, with maximum air temperature of 75° F (24° C), and 55% relative humidity.
Model CBC/CBR-103,104,105,106,107 2-7. COMPRESSOR SIZE AND LOAD Model CBC/ CBR 103 104 105 106 107 BTU Load 2830 2830 3840 3840 3840 CBC Motor HP CBR Motor HP UL CE UL CE R-22 R-134a R-22 R-134a 1/3 1/2 Remote 1/3 1/2 Compressor 1/2 1/2 Supplied 1/2 1/2 By Other 1/2 1/2 BTU load sized at evaporator temperature + 20 F or -6 C. 2-8.
Model CBC/CBR-103,104,105,106,107 2-9. FLUORESCENT LIGHTING AND LAMP REPLACEMENT No. Model CBR/CBC-103 CBR/CBC-104 CBR/CBC-105 CBR/CBC-106 CBR/CBC-107 of Lights 1 1 1 1 2 1 1 Size 36 in. (.914 m) 48 in. (1.22 m) 24 in. (.610 m) 36 in. (.914 m) 36 in. (.914 m) 36 in. (.914 m) 48 in. (1.22 m) Replacement: UL Units 1. Pull the lamp out of the sockets. 2. Remove the lamp guard caps. 3. Install new fluorescent bulb in reverse order. CE Units 1. Remove the lamp cover. 2. Rotate the lamp. 3.
Model CBC/CBR-103,104,105,106,107 2-10. HOT or COLD TOP ON A COLD BASE INSTALLATION INSTRUCTIONS 1. Remove bolts securing the top to the skid, and save bolts for later use. 2. Carefully set top on top of the cold base. Take care when moving the unit to prevent personal injury or damage to the refrigeration system. The units weigh between 400 (181 kg) and 580 lbs. (263 kg). Figure 2-1 3. Line up the 2 front holes and secure the top to the base using the bolts from step 1. Figure 2-1. 4.
Model CBC/CBR-103,104,105,106,107 SECTION 3. OPERATION 3-1. INTRODUCTION This section provides explanations of all controls, along with operating procedures and daily maintenance. Read the Introduction, Installation and Operation Sections before operating the unit. Wait at least 4 hours before plugging the unit into an electrical supply. The gases and oils in the refrigeration system need to settle before operating the compressor, or damage to the compressor could result. 3-2.
Model CBC/CBR-103,104,105,106,107 3-2.
Model CBC/CBR-103,104,105,106,107 3-3. BASIC OPERATION 1. Turn power switch to ON position. 2. Wait for temperature to reach operating temperature, 36 to 38° F (2.2 to 3.3° C). 3. Place chilled, prepackaged product into case. Do not stock product in the case beyond the load height limit of 9 inches (23 cm), or over the front edge. Product temperatures may become unsafe, and increase operating costs.
Model CBC/CBR-103,104,105,106,107 3-4. CLEANING (Continued) Every 3 Months: 1. Remove all electrical power supplied to the unit by unplugging the power cord from the wall, or by turning off the wall circuit breaker. 2. Remove all product from the unit. 3. Remove the riser and trays from the unit and clean with soap and water at a sink. 4. Clean interior surfaces with a soft cloth, soap and water.
Model CBC/CBR-103,104,105,106,107 3-5. PROGRAMMING 1. Press and hold for 4 seconds. The “DEF/SET” light flashes in display. Temperature Setpoint 2. Press the or to change the temperature setpoint, within 5 seconds. After 5 seconds, the last entered setpoint stays in memory. Other Parameters 3. Press to access the other parameters. Each press of the accesses the next parameter. The parameters are: d: (differential) (-15...15 range) LS: lower set; lower user-access setpoint limit (-55...
Model CBC/CBR-103,104,105,106,107 3-5. PROGRAMMING Continued dS: (defrost system (computation)) dF=digifrost feature; defrost start time based on total compressor running time. rt=real time; defrost start frequency, based on real time dI: (defrost interval) defrost frequency in hours, based on the selection of “dS” dE: (defrost endurance) total (maximum) length of a defrost cycle, expressed in minutes. (1...99 range) dL: (display lock) temperature display is locked during a defrost cycle. (0...
Model CBC/CBR-103,104,105,106,107 DIAGRAM FOR CBC MODEL 3-7 303
Model CBC/CBR-103,104,105,106,107 DIAGRAM FOR CBR MODEL 303 3-8
Model CBC/CBR-103,104,105,106,107 230V-50Hz-1ph-CE 3-9 303
Model CBC/CBR-103,104,105,106,107 RECOMMENDED PARTS LIST Item No. √ √ √ √ 1 1 1 2 2 2 2 2 3 3 4 5 6 7 8 √ √ √ √ √ √ √ 9 10 10 10 11 12 √ 13 √ 13 √ 14 15 15 15 16 17 Part No.