Henny Penny Cold Tops Model CMC/CMR-103 Model CMC/CMR-104 Model CMC/CMR-105 Model CMC/CMR-106 Model CMC/CMR-107 OPERATOR’S MANUAL
Model CMC/CMR-103,104,105,106,107 LIMITED WARRANTY FOR HENNY PENNY APPLIANCES Subject to the following conditions, Henny Penny Corporation makes the following limited warranties to the original purchaser only for Henny Penny appliances and replacement parts: NEW EQUIPMENT: Any part of a new appliance, except lamps and fuses, which proves to be defective in material or workmanship within two (2) years from date of original installation, will be repaired or replaced without charge F.O.B.
Model CMC/CMR-103,104,105,106,107 TABLE OF CONTENTS Section Page Section 1. INTRODUCTION ................................................................................................................... 1-1 1-1. Henny Penny Cold Tops .............................................................................................. 1-1 1-2. Features ....................................................................................................................... 1-1 1-3. Proper Care ..................
Model CMC/CMR-103,104,105,106,107 SECTION 1. INTRODUCTION 1-1. COLD TOPS The Henny Penny cold tops are full service units, designed to hold chilled or refrigerated products. The units are electronically controlled for easy use and for consistent operation. 1-2.
Model CMC/CMR-103,104,105,106,107 1-5. SAFETY The Henny Penny cold tops have many safety features incorporated. However, the only way to ensure a safe operation is to fully understand the proper installation, operation, and maintenance procedures. The instructions in this manual have been prepared to aid you in learning the proper procedures. Where information is of particular importance or safety related, the words NOTICE, CAUTION, and WARNING, are used. Their usage is described below.
Model CMC/CMR-103,104,105,106,107 SECTION 2. INSTALLATION 2-1. INTRODUCTION This section provides the installation for Henny Penny cold tops. Installation of this unit should be performed only by a qualified service technician. Do not puncture the unit with any objects such as drills or screws, or component damage or electrical shock could result. 2-2. UNPACKING The Henny Penny Cold Top has been tested, inspected, and expertly packed to insure arrival at its destination in the best possible condition.
Model CMC/CMR-103,104,105,106,107 2-2. UNPACKING (Continued) Take care when moving the fryer to prevent personal injury or damage to the refrigeration system. The CMC-107s weigh over 700 lbs. (318 kg). 2-3. ELECTRICAL 4. Peel off any protective covering from exterior of the cabinet. 5. Install the grids into unit. 6. Unpack sliding thermal doors and side glass. Install on rear and side of unit. 7. Your cold top is now ready for operation. The Cold Top is available as a 120 VAC, 60 Hz.
Model CMC/CMR-103,104,105,106,107 2-4. LOCATION Place the cold tops in an area where product can be loaded and unloaded without interruption. For proper operation, level the unit by adjusting the bolts under the base, and leave 3 feet (91.44 cm) clearance behind the unit for ventilation and service. For maximum efficiency, units should be operated in an air-conditioned environment, with maximum air temperature of 75° F (24° C), and 55% relative humidity.
Model CMC/CMR-103,104,105,106,107 2-7. COMPRESSOR SIZE AND LOAD Model CMC/ CMR 103 104 105 106 107 BTU Load 2860 2860 2830 2830 3840 CMC Motor HP CMR Motor HP UL CE UL CE R-22 R-134a R-22 R-134a 1/4 1/3 Remote 1/4 1/3 Compressor 1/3 1/2 Supplied 1/3 1/2 By Other 1/2 1/2 BTU load sized at evaporator temperature + 20 F or -6 C. 2-8.
Model CMC/CMR-103,104,105,106,107 2-9.
Model CMC/CMR-103,104,105,106,107 2-10. FLOURESCENT LIGHTING AND BULB REPLACEMENT Model CMR/CMC-103 CMR/CMC-104 CMR/CMC-105 CMR/CMC-106 CMR/CMC-107 No. of Lights 1 1 1 1 2 1 1 Size 36 in. (.914 m) 48 in. (1.22 m) 24 in. (.610 m) 36 in. (.914 m) 36 in. (.914 m) 36 in. (.914 m) 48 in. (1.22 m) UL Units 1. Pull the bulb out of the sockets. 2. Remove the bulb guard caps. 3. Install new fluorescent bulb in reverse order. CE Units 1. Remove the bulb cover. 2. Rotate the bulb. 3.
Model CMC/CMR-103,104,105,106,107 2-11. COLD TOP ON A COLD BASE INSTALLATION INSTRUCTIONS 1. Remove bolts securing the Cold Top to the skid, and save bolts for later use. 2. Carefully set Cold Top on top of the Cold Base. Take care when moving the fryer to prevent personal injury or damage to the refrigeration system. The CMC-107s weigh over 700 lbs. (318 kg). Figure 2-1 3. Line up the 2 front holes and secure the top to the base using the bolts from step 1. Figure 2-1. 4.
Model CMC/CMR-103,104,105,106,107 SECTION 3. OPERATION 3-1. INTRODUCTION This section provides explanations of all controls, along with operating procedures and daily maintenance. Read the Introduction, Installation and Opeation Sections before operating the unit. Wait at least 4 hours before plugging the unit into an electrical supply. The gases and oils in the refrigeration system needs to settle before operating the compressor, or damage to the compressor could result. 3-2.
Model CMC/CMR-103,104,105,106,107 3-2.
Model CMC/CMR-103,104,105,106,107 3-3. BASIC OPERATION 1. Turn power switch to ON position. 2. Wait for temperature to reach operating temperature, 34 to 38° F (1.1 to 3.3° C). 3. Place chilled product into case. Do not block the air return and air discharge vents with product. Product temperatures may become unsafe, and increase operating costs.
Model CMC/CMR-103,104,105,106,107 3-4. CLEANING (Continued) Every 3 Months: 1. Remove all electrical power supplied to the unit by unplugging the power cord from the wall, or by turning off the wall circuit breaker. 2. Remove all product from the unit. 3. Remove the riser and trays from the unit and clean with soap and water at a sink. 4. Clean interior surfaces with a soft cloth, soap and water.
Model CMC/CMR-103,104,105,106,107 3-5. PROGRAMMING 1. Press and hold for 4 seconds. The “DEF/SET” light flashes in display. Temperature Setpoint 2. Press the or to change the temperature setpoint, within 5 seconds. After 5 seconds, the last entered setpoint stays in memory. Other Parameters 3. Press to access the other parameters. Each press of the accesses the next parameter. The parameters are: d: differential (-15...15 range) LS: lower set; lower user-access setpoint limit (-55...
Model CMC/CMR-103,104,105,106,107 3-5. PROGRAMMING Continued dS: defrost system (computation); dF=digifrost Feature; defrost start time based on total compressor running time rt=real time; defrost start frequency, based on real time dI: defrost interval; defrost frequency in hours, based on the selection of “dS” dE: defrost endurance; total (maximum) length of a defrost cycle, expressed in minutes. (1...99 range) dL: display lock; temperature display is locked during a defrost cycle (0...
Model CMC/CMR-103,104,105,106,107 3-6. FLUORESCENT BULB REPLACEMENT UL Units 1. Pull the bulb out of the sockets. 2. Remove the bulb guard caps. 3. Install new fluorescent bulb in reverse order. CE Units 1. Remove the bulb cover. 2. Rotate the bulb. 3. Pull the lamp out of the sockets. 4. Install new fluorescent lamp in reverse order.
Model CMC/CMR-103,104,105,106,107 DIAGRAM FOR CMC MODEL 1002 3-8
Model CMC/CMR-103,104,105,106,107 DIAGRAM FOR CMR MODEL 3-9 1002
Model CMC/CMR-103,104,105,106,107 230V-50Hz-1ph-CE 1002 3-10
Model CMC/CMR-103,104,105,106,107 SECTION 4. PARTS INFORMATION 4-1. INTRODUCTION This section identifies and lists the replaceable parts of the Henny Penny Cold Top. 4-2. GENUINE PARTS Use only genuine Henny Penny parts in your cabinet. Using a part of lesser quality or substitute design may result in cabinet damage or personal injury. 4-3. HOW TO ORDER Once the part you want to order has been found in the Parts List, write down the following information: 1.
Model CMC/CMR-103,104,105,106,107 2 1 Item No. 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 Part No.
Model CMC/CMR-103,104,105,106,107 Use the chart below to identify the correct canopy glass assembly and the correct gas shock configuration. (Gas shock configuration is from left to right, customer side.) Item No. 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 Part No.
Model CMC/CMR-103,104,105,106,107 1 2 Item No. Part No.
Model CMC/CMR-103,104,105,106,107 RECOMMENDED PARTS LIST Item No. √ √ √ √ 1 1 1 2 2 2 2 2 3 3 4 5 6 7 √ √ √ √ √ √ 8 9 9 9 10 √ 11 √ 12 13 13 13 14 14 14 14 15 16 16 16 16 16 16 16 17 4-5 Part No.