Corp. Fryer User Manual

Model 690
Problem Cause Correction
PRESSURE SECTION (Continued)
Pressure does not • Not enough product in fryer • Place proper quantity of
build or product not fresh fresh product within
frypot to generate steam
• Metal shipping spacer not • Remove shipping spacer;
removed from deadweight see Unpacking section of
Operator’s Manual
• Lid open or not latched • Close and latch lid
• Solenoid valve leaking or • Check or clean solenoid
not closing valve per maintenance
section on the solenoid valve
• Deadweight valve leaking • Repair per maintenance sec-
tion on deadweight valve
• Pressure not programmed • Check programming
• Lid gasket leaking • Reverse gasket or lid needs
adjusted; see sections 2-10 &
2-13
• Safety relief valve leaking • Check and replace if
necessary per maintenance
section on the safety relief
valve
• Pressure pad broken or crushed • Replace pressure pads
1002 1-7
1-3. TROUBLESHOOTING
(Continued)