Corp. Fryer User Manual

Model 690
2-20. BLOWER ASSEMBLY The blower motor circulates air into the burner area to create
the correct heat for the fryer. If the blower fails, a sensor will
shut the power control valve down.
1. Make sure unit is off, and close and lock the lid.
Lid should be in locked down position. Failure to do so
could result in personal injury.
2. Remove the back shroud of the unit.
3. Using a Phillip’s-head screwdriver, remove the screw
securing the f ue to the blower.
4. Using a 3/8” socket or wrench, remove the 5 nuts securing
blower motor and pull motor from unit.
Blower Motor 5. Disconnect wires at junction box.
6. Remove the blower from unit.
7. Replace new blower in reverse order of procedures.
807 2-19