Corp. Fryer User Manual

Model 690
2-29. IGNITOR ASSEMBLY The 690 Model has electronic spark ignition that lights a
standing pilot.
Replacement 1. Remove electrical power supplied to the unit.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
TO AVOID INJURY, PROPERTY DAMAGE, OR
EXPLOSION, BEFORE REPLACING IGNITOR
ASSEMBLY, DO THE FOLLOWING:
• MOVE THE POWER/PUMP SWITCH TO THE
“OFF” POSITION.
• DISCONNECT MAIN CIRCUIT BREAKER AT
THE WALL, OR UNPLUG THE POWER CORD.
• TURN OFF THE MAIN GAS SUPPLY TO THE
FRYER AND DISCONNECT AND CAP THE
SUPPLY LINE TO FRYER.
2. Remove the control panel as discussed in section 2-7.
3. Disconnect the 1/4” gas line f tting from the pilot assembly.
4. Follow the wire from the spark ignitor to the module, and
remove the wire from the module.
5. Remove the left or right side panel, depending upon which
ignitor assembly will be removed.
6. Disconnect gas line (for the left ignitor assembly).
7. Remove the four screws securing burner assembly, and pull
the assembly from the unit.
8. Using a Phillips head screwdriver, remove screw securing
the ignitor assembly to the burner assembly, and pull the
ignitor assembly from the unit.
9. Secure new assembly with the screw previously removed,
making sure the assembly is turned to provide a 1/8” gap
between the spark ignitor and the hood of pilot assembly.
1002 2-27