MSDS

Henry
®
336 Floor Primer & Latex Liquid Additive
Page 3 of 6
MSDS Preparation Date (dd/mm/yyyy): 19/04/2013
Wear suitable protective equipment during handling. Use with adequate ventilation. Training
the workers on the potential health hazards associated with product vapor, dust or fume is
important. Secondary inhalation exposures could occur when cleaning equipment, or when
removing or laundering the clothing. Avoid breathing vapour or mist. Avoid contact with skin,
eyes and clothing. Keep away from heat and sources of ignition. Keep away from oxidizing
materials. Keep containers tightly closed when not in use. Wash thoroughly after handling.
Safe Handling procedures
:
Store in a cool, dry, well-ventilated area. No smoking in the area. Do not store near any
incompatible materials (see Section 10). Storage area should be clearly identified, clear of
obstruction and accessible only to trained and authorized personnel. Protect against
physical damage.
Storage requirements
:
Incompatible materials
:
See Section 10.
Special packaging materials
:
Always keep in containers made of the same materials as the supply container.
Ventilation and engineering measures
Use with adequate ventilation. Provide adequate cross air circulation. Use general or local
exhaust ventilation to maintain air concentrations below recommended exposure limits.
:
SECTION 8 - EXPOSURE CONTROLS AND PERSONAL PROTECTION
Respiratory protection
:
Not required under normal conditions of handling. If mists are formed, or in confined
spaces, respiratory protection may be required.
NIOSH-approved respirators are recommended.
Skin protection
:
Where contact is likely, impervious gloves are recommended. Advice should be sought from
glove suppliers.
If splashing might occur, wear eye protection such as safety glasses with side shields.
:
Eye / face protection
Other protective equipment
:
Wear sufficient clothing to prevent skin contact. An eyewash station and safety shower
should be made available in the immediate working area.
General hygiene considerations
:
Avoid contact with eyes, skin and clothing. Avoid breathing vapour or mist. Do not eat,
drink or smoke when using this product. Clean all equipment and clothing at end of each
work shift.
Permissible exposure levels
:
For individual ingredient exposure levels, see Section 3.
Physical state
liquid
:
Appearance
Milky, white liquid.
:
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
Odour
Slight odour.
:
Odour threshold
N/Av
:
pH
9.0
:
1.01
:
Specific gravity
:
100°C / 212°F
Boiling point
Melting/Freezing point
N/Av
:
N/Av
:
Coefficient of water/oil distribution
Vapour pressure (mmHg @ 20° C / 68° F)
same as water
:
Solubility in water
miscible
:
Vapour density (Air = 1)
same as water
:
Evaporation rate (n-Butyl acetate = 1)
:
same as water
85 - 90 (30 min. @ 135°C /
275°F)
:
Volatiles (% by weight)
:
Volatile organic Compounds (VOC's)
0 g/L (calculated at 21°C
/ 70°F, SCAQMD)
Particle size
General Info.
:
:
N/Av
Weight / Gallon: 8.4 (water =
8.3)
Stable under the recommended storage and handling conditions prescribed.
Stability and reactivity
:
SECTION 10 - REACTIVITY AND STABILITY DATA
Hazardous polymerization
Hazardous polymerization does not occur.
:
Conditions to avoid
Extreme heat.
:
Oxidizing agents.
Materials To Avoid And Incompatibility
:
None known, refer to hazardous combustion products in Section 5.
Hazardous decomposition products
:
SECTION 11 - TOXICOLOGICAL INFORMATION