MSDS

Henry
®
345 Premixed Patch n' Level Page 3 of 7
23-Apr-2015
Personal precautions : Restrict access to area until completion of clean-up. All persons dealing with
clean-up should wear the appropriate chemically protective equipment.
Protective equipment : Refer to Section 8 on this Safety Data Sheet, EXPOSURE CONTROLS /
PERSONAL PROTECTION, for additional information on acceptable personal
protective equipment.
Emergency Procedures : If a spill/release in excess of the EPA reportable quantity is made into the
environment, immediately notify the national response center in the United States
(phone: [phone]).
US CERCLA Reportable quantity (RQ): None reported.
Methods and materials for containment and cleaning up
: Ventilate area of release. Stop spill or leak at source if safely possible. Contain
product with inert absorbent material, preventing it from entering sewer lines or
waterways. Gather up spilled material and place in suitable container for later
disposal (see Section 13). Residual of product, while still wet, can be cleaned up
with warm soapy water. Notify the appropriate authorities as required.
Prohibited materials : Avoid strong oxidizing agents
Environmental precautions : Do not allow product to enter drains or waterways. Do not allow material to
contaminate ground water system.
Reference to other sections : See Section 14 for disposal information.
Safe handling procedures : Observe good hygiene standards. Use only with adequate ventilation. Do not eat,
drink or smoke in the work area. Wash thoroughly after handling. Do not get in
eyes, on skin, or on clothing. Avoid repeated or prolonged skin contact. Avoid
breathing vapors or mists of this product. Sanding and grinding dusts may be
harmful if inhaled. When removing this product from existing flooring (i.e. during a
renovation), wear safety goggles and respiratory protection from dust due to
blasting, chipping, or mechanically pulverizing. Wear protective clothing to prevent
skin contact. Promptly remove any clothing that becomes contaminated. Clean
contaminated clothing before reuse. Keep container tightly closed.
Storage requirements : Store in a cool, dry, well-ventilated area. Store away from heat and open flame.
Avoid storing in direct sunlight. Store in original container. Keep tightly closed when
not in use. Do not reuse empty container without commercial cleaning or
reconditioning.
Incompatible materials : See Section 10.
Special packaging materials : Always keep in containers made of the same materials as the supply container.
Permissible Exposure Limits : No exposure limits have been established for the product itself. Below are exposure
limits for the components in the product.
Ingredients
CAS #
ACGIH TLV
TWA STEL
OSHA PEL
PEL STEL
Crystalline silica
14808-60-7
0.025 mg/m
3
N/Av
(respirable
fraction)
0.1 mg/m
3
N/Av
(respirable)
(Final rule limit)
2-Butoxyethanol
111-76-2
20 ppm N/Av
50 ppm (skin) N/Av
Engineering Controls : Use general or local exhaust ventilation to maintain air concentrations below
recommended exposure limits. Ventilation should effectively remove and prevent
buildup of any vapor or mist generated from the handling of this product.
Personal Protection Equipment
Eye / face protection : Safety glasses must be worn when using this product. During operations where
airborne dust is generated, wear chemical goggles.
SECTION 7 – HANDLING AND STORAGE
SECTION 8 – EXPOSURE CONTROLS AND PERSONAL PROTECTION