SDS
Henry
®
430 ClearPro
Clear VCT Floor Adhesive Page 3 of 7
01-Mar-2015
: Ventilate area of release. Stop spill or leak at source if safely possible. Contain
product with inert absorbent material, preventing it from entering sewer lines or
waterways. Gather up spilled material and place in suitable container for later
disposal (see Section 13). Residual of product, while still wet, can be cleaned up
with warm soapy water. Notify the appropriate authorities as required.
Prohibited materials : None known.
Environmental precautions : Do not allow product to enter drains or waterways. Do not allow material to
contaminate ground water system.
Reference to other sections : See Section 14 for disposal information.
Safe handling procedures : Wear suitable protective equipment during handling. (See Section 8.) Observe
good hygiene standards. Use only with adequate ventilation. Wash thoroughly after
handling. Avoid contact with eyes, skin, or clothing. Sanding and grinding dusts
may be harmful if inhaled. When removing this product from existing flooring (i.e.
during a renovation), wear safety goggles and respiratory protection from dust due
to blasting, chipping, or mechanically pulverizing. Keep container tightly closed.
Storage requirements : Store in a cool, dry, well-ventilated area. Store away from heat and open flame.
Avoid storing in direct sunlight. Store in original container. Keep tightly closed when
not in use. Do not reuse empty container without commercial cleaning or
reconditioning.
Incompatible materials : See Section 10.
Special packaging materials : Always keep in containers made of the same materials as the supply container.
Permissible Exposure Limits : No exposure limits have been established for the product itself. Below are exposure
limits for the components in the product.
Ingredients
CAS #
ACGIH TLV
TWA STEL
OSHA PEL
PEL STEL
No hazardous ingredients
N/Ap
N/Ap N/Ap
N/Ap N/Ap
Engineering Controls : Use general or local exhaust ventilation to maintain air concentrations below
recommended exposure limits. Ventilation should effectively remove and prevent
buildup of any vapor generated from the handling of this product.
Personal Protection Equipment
Eye / face protection : Chemical goggles or safety glasses, as appropriate for the job.
Skin protection : Wear gloves which are impervious to the material. Materials such as nitrile rubber
or Viton (fluorocarbon rubber) are recommended.
Body protection : Where extensive exposure to product is possible, use resistant coveralls, apron and
boots to prevent contact.
Respiratory protection : Under normal conditions of use with adequate ventilation, respiratory protection
should not be necessary. If work process generates excessive quantities of vapor
or dust, or exposures in excess of any PEL, wear an appropriate organic vapor
respirator.
Site safety equipment : An eyewash station and safety shower should be made available in the immediate
working area.
General hygiene considerations : Avoid contact with eyes, skin and clothing. Avoid breathing vapors/dust. Do not eat,
drink or smoke when using this product. Upon completion of work, wash hands
thoroughly. Remove soiled clothing and wash it thoroughly before reuse. Clean all
equipment and clothing at end of each work shift.
Physical state : Paste Appearance : Beige paste
Odor : Mild Odor threshold : N/Av
SECTION 7 – HANDLING AND STORAGE
SECTION 8 – EXPOSURE CONTROLS AND PERSONAL PROTECTION
SECTION 9 – PHYSICAL AND CHEMICAL PROPERTIES