MSDS

HENRY
®
554 LevelPro
™
Primer
Page 3 of 6
MSDS Revision Date (dd/mm/yyyy): 13/05/2013
SECTION 8 - EXPOSURE CONTROLS AND PERSONAL PROTECTION
Exposure Limits
ACGIH TLV
OSHA PEL
STEL
TWA
STEL
PEL
Ingredients
N/Av
N/Av
N/Av
N/Av
None reported.
:
Use with adequate ventilation. Provide adequate cross air circulation. Use general or local
exhaust ventilation to maintain air concentrations below recommended exposure limits.
Ventilation and engineering measures
Respiratory protection is required if the concentrations exceed the TLV. NIOSH-approved
respirators are recommended.
:
Respiratory protection
Gloves impervious to the material are recommended. Advice should be sought from
glove suppliers.
:
Skin protection
Eye / face protection
:
Safety goggles or glasses as appropriate for the job.
Wear sufficient clothing to prevent skin contact. An eyewash station and safety shower
should be made available in the immediate working area.
:
Other protective equipment
Avoid contact with eyes, skin and clothing. Avoid breathing vapors, fumes or dust. Do not
eat, drink or smoke when using this product. Clean all equipment and clothing at end of
each work shift.
:
General hygiene considerations
Physical state
Pasty liquid.
:
Appearance
Light pink paste.
:
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
Odour
Sweet odour.
:
Odour threshold
N/Av
:
pH
N/Av
:
1.036
:
Specific gravity
:
100°C (212°F)
Boiling point
Melting/Freezing point
N/Av
:
N/Av
:
Coefficient of water/oil distribution
Vapour pressure (mmHg @ 20° C / 68° F)
17.0
:
Solubility in water
Dispersible
:
Vapour density (Air = 1)
0.62
:
Evaporation rate (n-Butyl acetate = 1)
:
1
N/Av
:
Volatiles (% by weight)
:
Volatile organic Compounds (VOC's)
N/Av
Weight / Gallon: N/Av
N/Av
:
:
General Info.
Particle size
:
Flash point
> 93.3°C (200°F)
:
Setaflash Closed Tester
Auto-ignition temperature
:
N/Av
Flash point Method
N/Av
N/Av
:
:
Upper flammable limit (% by vol.)
Lower flammable limit (% by vol.)
Flame Projection Length
Flashback observed
:
:
Not applicable.
Not applicable.
Stable under the recommended storage and handling conditions prescribed.
Stability and reactivity
:
SECTION 10 - REACTIVITY AND STABILITY DATA
Hazardous polymerization
Hazardous polymerisation does not occur.
:
Conditions to avoid
Extreme heat. Temperatures above: 32.2°C (90°F).
:
Oxidizing agents; Acids.
Materials To Avoid And Incompatibility
:
None known, refer to hazardous combustion products in Section 5.
Hazardous decomposition products
: