Instructions / Assembly

TECHNICAL DATA SHEET
HE555 - FIBERED ALUMINUM ROOF COATING
Last Rev Date: 09/23/2013
Physical Properties
Flash PointAppearance
Liquid 105º F min.
Solids By Weight
52% min. (ASTM D2824)
Maximum VOCBase
Asphalt and aluminum 400 g/l
Stormer Viscosity
75 - 105 K.U. (ASTM D582)
Reflectance Color
Black fluid with silver pigment 53% min.
Weight Per Gallon
7.7- 8.3 lbs (ASTM D1475)
Fire Resistance
Pass (UL 790)
Approvals and Certifications
Manufactured to meet the requirements of ASTM D-2824, Type III.
Description
HE555 - FIBERED ALUMINUM ROOF COATING is an ultra premium fibered aluminum coating that forms a shiny,
tough, reflective surface. It can decrease heating and air conditioning costs, and keeps the inside temperature of a
building up to 20ºF cooler in summer. NOT TO BE SOLD IN SOUTHERN CALIFORNIA.
Usage
·
Designed for use on the roofs of barns, homes, garages and mobile homes
· Smooth surfaced roofing, built-up asphalt, prepared roll roofing, weathered galvanized iron and tin. (Do not use on
shingles of any kind).
·
Seals hairline cracks and pinholes to help increase the water resistance of the roof.
·
Produces a bright aluminum roof surface which reflects damaging ultraviolet sunrays
Coverage
Approximately 1.25 - 2.0 gallons per 100 square feet. As roof slope increases, coverage rate should be reduced to
prevent run-off or slippage.
Surface Preparation
Carefully inspect area to be coated, including around pipes, chimneys, equipment, roof edges, and walls. Repair all
cracks, breaks, splits, and holes by embedding polyester fabric or open mesh glass fabric between 2 heavy coats of roof
cement, applied over and at least 2 inches beyond repair. Allow mastic to cure 30 days before coating. Surface must be
clean, dry, and in good repair. Remove rust by wire brushing. Sweep or hose down area to remove all dust, dirt, and
residues. Scrub areas where water ponds with detergent and water, and rinse well. Allow to dry thoroughly. New,
galvanized metal and hard to clean surfaces such as built-up roof from which the gravel has been removed should be
primed with a light coat of asphalt primer, just enough to seal the surface without any build-up of film. Allow primer to dry
thoroughly before applying HE555 - FIBERED ALUMINUM ROOF COATING.
Henry Company 909 N. Sepulveda, Ste 650, El Segundo CA 90245-2754
Technical Services Phone: [phone] - Email: [e-mail]
The Henry Company is the parent company of Bakor, Inc.
www.henry.com
TECH HE555