Owner's Instructions

Do
• Make sure you DRY vacuum the carpet before washing.
• Keep your machine clean.
• Keep lters clean.
• Regularly clean the water level limiting oat safety valve and examine for signs of damage or correct
operation.
• Keep hoses and tubes clear.
• Replace any worn or damaged parts immediately.
• Regularly examine the power cord, if damage is found, power cord must be replaced by a qualied
person using the correct Numatic original part.
• Keep diuser lter (where tted) clean.
Don’t
• Use steam cleaners or pressure washers to clean the machine or use the machine in the rain.
• Immerse in water for cleaning.
• Allow any inexperienced repairs. Call the experts.
• Use wet if oat valve is not functioning or tted.
• Use to suck up hot ashes, or lighted cigarette ends.
• Run the machine over the power cable during operation as a hazard may occur.
• Pull on the cable to unplug the machine from the power supply.
• Walk over-wet carpets, upholstery or fabrics.
• Walk on clean carpets until fully dry.
• Spray onto people or animals.
• Attempt machine maintenance or cleaning unless the power supply plug has been removed from the
supply outlet.
Fault Finding
This machine can be used for wet pick up and cleaning carpet and upholstery
Spray extraction machines only
• Use only approved cleaning preparations.
• Use defoamer if necessary.
Use of detergents
When using any detergent with this machine, please ensure you have read the safety data on the container
and you are familiar with the procedures to clear up spills, inhalation, skin and eye contact.
Wet mode / Spray extraction maintenance/fault nding
If the vacuum cleaner stops working switch o and remove the plug from the wall before investigating were
the fault lies.
If the vacuum cleaner has a blockage and will not pick up liquid, switch o and remove the plug from the
wall, has the oat valve operated, this will shut o the suction and the pitch of the vacuum motor will change
Remove the power head and empty the liquid out of the container, if the container is empty, check that the
oor tool wands and hose are not blocked.
If the spray nozzle is blocked a pin maybe used to clear the blockage.
No spray from nozzle and the pump tone changes, the solution tank is empty, rell the solution tank.
Flush the system with clean water after use.
After use always inspect the machine for damage.