User's Manual

Adjusting the Equalizer

Select “EQ”.

Adjust the Treble or Bass up or down.

Select the Reset button to restore the default settings.

Adjusting the Audio Quality

Selects the transcoding option for rebroadcasting audio from one HEOS

device to another HEOS device (or group of devices) across the network.

When set to “Normal”, high bit rate audio sources originating from the first

device (such as AUX input, WAV, FLAC and PCM) will be transcoded to

ensure the highest level of reliability for the audio stream.

Select “Quality”.

Select Normal (default) or High.

If you have selected High and you experience audio dropouts when streaming

sources from one device to other devices, please select Normal (default).

This setting does not affect the AUX input when played on the connected device

by itself (there are no other devices grouped to it), in which case the original

source quality and bit rate are maintained and there is no inherent delay.

Advanced Settings

Caution

Adjusting these settings may disconnect your device from your network

and possibly render your device unusable. Do not use these features

unless you are comfortable making advanced adjustments.

Network Settings

Select “Advanced”.

Select “Network Settings”.

Scroll down to see all of the options for

a. Network Interface (wired or wireless)

b. Wireless network settings

c. Manual or static IP address for your device

Select Save Settings to apply the new settings or

Cancel Changes to revert to the previous settings.

Contents Setup Use Troubleshooting Status LED Appendix