Owner's Manual

Page 6 )RUWHFKQLFDOTXHVWLRQVSOHDVHFDOO Item 56407
OPERATION
5HDGWKH(17,5(,03257$176$)(7<
,1)250$7,21VHFWLRQDWWKHEHJLQQLQJ
RIWKLVPDQXDOLQFOXGLQJDOOWH[WXQGHU
VXEKHDGLQJVWKHUHLQEHIRUHVHWXSRUXVHRI
WKLVSURGXFW
Tool Set Up
7235(9(176(5,286,1-85<)520
$&&,'(17$/23(5$7,21
0DNHVXUHWKDWWKH7ULJJHULVLQWKHRIISRVLWLRQDQG
XQSOXJWKHWRROIURPLWVHOHFWULFDORXWOHWEHIRUH
SHUIRUPLQJDQ\SURFHGXUHLQWKLVVHFWLRQ
127,&( Clean the loading end of the bit to remove
any debris, then lubricate the bit with grease.
&OHDQELWWKHQOXEULFDWHZLWKJUHDVH
Install Collarless Bit
1. Pull the Lock Lever to the side, just far
enough to allow the Bit to be inserted.
)ODW
1RWFK
2
1
/RFN
/HYHU
1RWH Flat Notch on Collar-less Bit
must face the Lock Lever.
2. Insert Bit with the Flat Notch facing the Lock Lever.
/RFN/HYHU/RFN/HYHU
3. Slide the Bit in as far as it will go.
4. Pull the Lock Lever back until it
locks the Bit into place.
1RWH Lock Lever will not lie flat against the chuck.
)ODW1RWFK)ODW1RWFK
3OD\3OD\
5. When the Bit is installed, there will be
DSSUR[LPDWHO\ƎRISOD\DORQJWKH)ODW
Notch of the shank. Physically check that
the Bit is secure before operating.
Install Collared Bit
1. Pull the Lock Lever open about 70-80°
to the second engaging position.
2. Insert the collared Bit.
3. Slide the Bit in as far as it will go.
1
2
5HWDLQLQJ
5LQJ

4. Return the Lock Lever to its original
position to lock the Bit in place.