Use and Care Manual

Fits all sizes
PARTS
1- Right Side Frame
1- Left Side Frame
2- Extender Bars
1- Center Bracket
7- Carpet Rollers
1- Wrench
6- Bolts
6- Washers
6- Nuts
ASSEMBLY INSTRUCTIONS
STEP 1: Swing out cross
arms on both side pieces
to 90 degrees.
NOTE: Each set of
key holes
correspond to bed
frame size. An
Extender bar is
included for King
and Cal King
KING AND CAL
KING EXTENDER:
Line the rivets on
the extender with
the key holes on the
frame and lock into
place.
STEP 2: Place rivets
of the cross arms into
appropriate key
holes.
STEP 3: Slide rivets to
lock in place. Repeat
step 2 and 3 on other
side.
STEP 4: Place support
bar in center and align
with holes on top.
STEP 5: Place bolt into hole on
top center of bed frame.
STEP 6: Secure washer and nut
with enclosed wrench. Repeat
steps 6-7 on other side. Use the
wrench tighten the bolt tightly
STEP 8: Bed frame is assembled
and ready for use.
STEP 9: Headboard bracket
can be attached to headboard
if necessary.
STEP 7: Slide carpet rollers
into bed frame legs. After
locating the bed frame to its
final position, lock the
rollers. To lock the rollers,
rotate the arm counter
clockwise until it stops.
9
7
6
5
4
1
8
QUEEN
TWIN
3
2
BED
KING
EXTENDER
BED
CAL KING