SDS

Rinse with water. Get medical attention if irritation develops and persists.
Eye contact
Rinse mouth. If ingestion of a large amount does occur, call a poison control center immediately.
Ingestion
Direct contact with eyes may cause temporary irritation.
Most important
symptoms/effects, acute and
delayed
Treat symptomatically.
Indication of immediate
medical attention and special
treatment needed
Ensure that medical personnel are aware of the material(s) involved, and take precautions to
protect themselves.
General information
5. Fire-fighting measures
Alcohol resistant foam. Water fog. Dry chemical powder. Carbon dioxide (CO2).
Suitable extinguishing media
Do not use water jet as an extinguisher, as this will spread the fire.
Unsuitable extinguishing
media
During fire, gases hazardous to health may be formed.
Specific hazards arising from
the chemical
Self-contained breathing apparatus and full protective clothing must be worn in case of fire.
Special protective equipment
and precautions for firefighters
Move containers from fire area if you can do so without risk.
Fire fighting
equipment/instructions
Use standard firefighting procedures and consider the hazards of other involved materials.
Specific methods
No unusual fire or explosion hazards noted.
General fire hazards
6. Accidental release measures
Keep unnecessary personnel away. For personal protection, see section 8 of the SDS.
Personal precautions,
protective equipment and
emergency procedures
Large Spills: Stop the flow of material, if this is without risk. Use water spray to reduce vapors or
divert vapor cloud drift. Dike the spilled material, where this is possible. Cover with plastic sheet to
prevent spreading. Absorb in vermiculite, dry sand or earth and place into containers. Following
product recovery, flush area with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS.
Methods and materials for
containment and cleaning up
Avoid discharge into drains, water courses or onto the ground.
Environmental precautions
7. Handling and storage
Avoid prolonged exposure. Use care in handling/storage.
Precautions for safe handling
Store in original tightly closed container. Store away from incompatible materials (see Section 10
of the SDS).
Conditions for safe storage,
including any incompatibilities
8. Exposure controls/personal protection
Occupational exposure limits
US. Workplace Environmental Exposure Level (WEEL) Guides
Value
Type
Form
Components
TWA 10 mg/m3 Aerosol.Propylene glycol (CAS
57-55-6)
No biological exposure limits noted for the ingredient(s).
Biological limit values
Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates
should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation,
or other engineering controls to maintain airborne levels below recommended exposure limits. If
exposure limits have not been established, maintain airborne levels to an acceptable level.
Appropriate engineering
controls
Individual protection measures, such as personal protective equipment
Wear safety glasses with side shields (or goggles).
Eye/face protection
Skin protection
Wear appropriate chemical resistant gloves.
Hand protection
Hercules Cyrotek-100 AL SDS US
925784 Version #: 01 Revision date: - Issue date: 22-April-2015
2 / 6