Safety Data Sheet

6. Accidental release measures
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Eliminate all
ignition sources (no smoking, flares, sparks, or flames in immediate area). Wear appropriate
protective equipment and clothing during clean-up. Avoid breathing mist or vapor. Do not touch
damaged containers or spilled material unless wearing appropriate protective clothing. Ventilate
closed spaces before entering them. Local authorities should be advised if significant spillages
cannot be contained. For personal protection, see section 8 of the SDS.
Personal precautions,
protective equipment and
emergency procedures
Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate area). Keep
combustibles (wood, paper, oil, etc.) away from spilled material. Take precautionary measures
against static discharge. Use only non-sparking tools.
Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is
possible. Use a non-combustible material like vermiculite, sand or earth to soak up the product
and place into a container for later disposal. Following product recovery, flush area with water.
Small Spills: Absorb with earth, sand or other non-combustible material and transfer to containers
for later disposal. Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS.
Methods and materials for
containment and cleaning up
Avoid discharge into drains, water courses or onto the ground.
Environmental precautions
7. Handling and storage
Do not handle, store or open near an open flame, sources of heat or sources of ignition. Protect
material from direct sunlight. Explosion-proof general and local exhaust ventilation. Take
precautionary measures against static discharges. All equipment used when handling the product
must be grounded. Use non-sparking tools and explosion-proof equipment. Do not taste or
swallow. Avoid breathing mist or vapor. Avoid contact with eyes, skin, and clothing. Avoid
prolonged exposure. When using, do not eat, drink or smoke. Wear appropriate personal
protective equipment. Wash hands thoroughly after handling. Observe good industrial hygiene
practices.
Precautions for safe handling
Store locked up. Keep away from heat, sparks and open flame. Prevent electrostatic charge
build-up by using common bonding and grounding techniques. Store in a cool, dry place out of
direct sunlight. Store in original tightly closed container. Store in a well-ventilated place. Keep in an
area equipped with sprinklers. Store away from incompatible materials (see Section 10 of the
SDS).
Conditions for safe storage,
including any incompatibilities
8. Exposure controls/personal protection
Occupational exposure limits
U.S. - OSHA
Form
ValueComponents Type
TWA 0.8 mg/m3 Unspecified.Fumed Silica (CAS
112945-52-5)
20 mppcf Unspecified.
US. OSHA Specifically Regulated Substances (29 CFR 1910.1001-1053)
ValueComponents Type
STEL 5 ppmPolyvinyl chloride (CAS
9002-86-2)
TWA 1 ppm
US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)
ValueComponents Type
PEL 2400 mg/m3Acetone (CAS 67-64-1)
1000 ppm
PEL 200 mg/m3Cyclohexanone (CAS
108-94-1)
50 ppm
PEL 590 mg/m3Methyl ethyl ketone (CAS
78-93-3)
200 ppm
Hercules PVC Medium Body Fast Set Cement SDS US
948998 Version #: 01 Revision date: - Issue date: 02-April-2019
3 / 12