Safety Data Sheet

Methods and materials for
containment and cleaning up
Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate area). Take
precautionary measures against static discharge. Use only non-sparking tools. Keep combustibles
(wood, paper, oil, etc.) away from spilled material.
Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is
possible. Cover with plastic sheet to prevent spreading. Use a non-combustible material like
vermiculite, sand or earth to soak up the product and place into a container for later disposal. Use
water spray to reduce vapors or divert vapor cloud drift. Prevent entry into waterways, sewer,
basements or confined areas. Following product recovery, flush area with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS.
Environmental precautions
Avoid discharge into drains, water courses or onto the ground.
7. Handling and storage
Precautions for safe handling
Vapors may form explosive mixtures with air. Do not handle, store or open near an open flame,
sources of heat or sources of ignition. Protect material from direct sunlight. Take precautionary
measures against static discharges. All equipment used when handling the product must be
grounded. Use non-sparking tools and explosion-proof equipment. Do not taste or swallow. Avoid
breathing mist or vapor. Avoid contact with skin. Avoid contact with eyes. Avoid prolonged
exposure. Avoid contact with clothing. Provide adequate ventilation. Wear appropriate personal
protective equipment. Observe good industrial hygiene practices. When using, do not eat, drink or
smoke. Wash hands thoroughly after handling.
Conditions for safe storage,
including any incompatibilities
Store locked up. Keep away from heat, sparks and open flame. Prevent electrostatic charge
build-up by using common bonding and grounding techniques. Store in original tightly closed
container. Store in a cool, dry place out of direct sunlight. Store in a well-ventilated place. Store
away from incompatible materials (see Section 10 of the SDS). Keep in an area equipped with
sprinklers.
8. Exposure controls/personal protection
Occupational exposure limits
U.S. - OSHA
Value
Type
Form
Components
TWA 0.8 mg/m3 Unspecified.Colloidal silicon dioxide
(CAS 112945-52-5)
20 mppcf Unspecified.
US. OSHA Specifically Regulated Substances (29 CFR 1910.1001-1050)
Value
TypeComponents
STEL 5 ppmPolyvinyl chloride (CAS
9002-86-2)
TWA 1 ppm
US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)
Value
Type
Form
Components
PEL 2400 mg/m32-Propanone (CAS 67-64-1)
1000 ppm
PEL 200 mg/m3Cyclohexanone (CAS
108-94-1)
50 ppm
PEL 590 mg/m3Furan, Tetrahydro- (CAS
109-99-9)
200 ppm
PEL 590 mg/m3Methyl ethyl ketone (CAS
78-93-3)
200 ppm
PEL 5 mg/m3 Respirable fraction.Polyvinyl chloride (CAS
9002-86-2)
15 mg/m3 Total dust.
SDS USHERCULES PVC CEMENT HEAVY BODY, SLOW SET CLEAR AND GRAY
922218 Version #: 02 Revision date: 12-8-2017 Issue date: 8-4-2014
3 / 10