User's Manual

2
• This manual.
• HA BRITSTRIP main unit.
• Power Supply labelled HA-PSU03.
• IEC Cable.
Depending on your system requirements, you will need several XLR and
MONO jack cables to hook up your system. Please check your input sources
and output destinations and purchase the correct cables.
The power supply is of the auto switching type so it works worldwide without
adjusting anything. In case your country uses a different mains cable other
than the one provided in the box, just get the correct one and you are done.
Basic audio connections are just balanced input and output connections by
means of XLR.
In case you want to make use of the external sidechain facilities, additional
MONO Jack cables are needed as explained below:
If you want to be able to trigger the BRITSTRIP Successor-like detector with
an external signal, a MONO jack is needed. If, in addition to this, you want to
be able to further externally process the internal detector signal and return it
into the unit, another additional MONO jack is needed.
In case you have TRS JACKS instead of MONO (TS) ones, those are compatible
as well, but keep in mind that the signals are unbalanced.
The HA BRITSTRIP is able to accept input levels in excess of those that any
interface can provide, so the chance that its input is overloaded is rare.
However, it is able to provide output levels in excess of those that most
interfaces can accept, so please keep this in mind.