User's Manual

9
The same applies on the Lo shelf, peak settings will enhance your low end
without sounding muddy while the shelf setting may be too much when
doing large boosts.
Again, the best way is experimenting!!
LIST OF CONTROLS
The list of controls, from left to right, is as follows:
- LIFT: Lifts the ground from the THRU input.
- LINE: Swaps the unit into LINE mode.
- +48v: Activates Phantom power.
- PAD: Lowers the input gain by 20dB in MIC mode.
- LOZ: Switches the input impedance from 1200 to 300 ohm in MIC
mode.
- INPUT GAIN SWITCH: Sets the input gain in 5 dB increments from 30
to 80 dB in MIC mode, 40 dB less in LINE mode.
- HI SHELF FREQ SELECTION: Selects the hi shelf corner frequency.
- HI SHELF BOOST/CUT: Sets the amount of gain boost/cut, being 0 at
6 o´clock.
- HI SHELF PEAK: Switches the shelf response curve to PEAK.
- MID BAND FREQ. SELECTION: Selects the mid band´s peak frequency.
- MID BAND BOOST/CUT: Sets the amount of gain boost/cut, being 0
at 6 o´clock.
- MID BAND Q SWITCH: Sets the higher Q for the mid band.
- LO SHELF FREQ SELECTION: Selects the lo shelf corner frequency.
- LO SHELF BOOST/CUT: Sets the amount of gain boost/cut, being 0 at
6 o´clock.
- LO SHELF PEAK: Switches the shelf response curve to PEAK.