Owner Manual

15
STEP 6: TUBE INSTALLATION
Components List
 Lattice tubing
 End caps
Tools Required
FIRST: Starting 2” away from ledger
board, install the lattice tubes with 2”
spacing between each lattice tube.
Measuring at each end of lattice tube to
ensure both sides have equal overhang.
Place the 2” x 2” lattice tube so that all
the seams face towards the top side.
Secure tubes using the 8# x 2-1/2” SMS
with neoprene washers to each rafter.
NOTE: By laying out a few 2” x 2”
tubes at a time and securing every other
tube this will be 4” on center with 2”
spacing between tubes.
SECOND: The remainder of all the 2” x
6-1/2”, 3” x 8”, and 2” x 2” end caps
can now be installed.