User Manual

Stand and tub connections
Position the pump mount bracket between the timer
leg and the filter/regulator leg of the stand assembly.
Attach the pump mount bracket to the stand using (2)
1/4-20 x 1/2 hex bolts, (2) #10 flat washers, (2) 1/4"
lock washers and (2) 1/4" acorn nuts per leg (see fig.1).
Attach the pump to the stand using the (2) 1/4-20 x 1
hex bolts, (2) 1/4" flat washers, (2) 1/4" lock washers
and (2) 1/4" hex nuts per leg (see fig.1).
STEP 1
Assembly
STEP 2
Hex bolt
1/4-20 x 1
1/4" Flat Washer
Hex bolt
1/4-20 x 1/2
Flat washer #10
1/4" Acorn nut
1/4" Lock Washer
Fluid hose connections
Connect the drain hose assembly to the flare connector
on the bottom of the tub and tighten. This can easily be
disconnected when inserting into a 5-gallon can.
(see fig.2).
Ensure bulkhead DOES NOT TURN when tightening.
Attach the siphon filter to the 23" length of black hose by
inserting the barb into the end of the hose. Slide the
white plastic plug over the opposite end of the hose
so that the threads are in the direction of the filter
(see fig.2).
Attach the other end of the 23" hose to the lower (IN)
90° barb on the pump (see fig.2)
Run the 16" black hose from the upper (OUT) 90° barb
on the pump to the 90° barb at the rear-left corner
on the underside of the tub (see fig.2)
Attach the white plastic muffler to the exhaust
port of the pump (see fig.2).
STEP 3
STEP 4
STEP 6
STEP 7
STEP 5
16" Black Hose
23" Black HoseMuffler
Plug
Siphon Filter
Drain hose assembly
Flare connector
fig.2
Hex bolt
1/4-20 x 1
1/4" Flat Washer
fig.1
Hex bolt
1/4-20 x 1/2
Flat washer #10
1/4" Acorn nut
1/4" Hex nut
1/4" Lock Washer
Page 5 of 19