User Manual

001-702 Bolt Hex 1/4-20 x 1/2 Z 2 ea.
001-705 Flat washer 1/4" 2 ea.
002-158 Screw #14 x 3/4 - zinc 2 ea.
002-160 Nut Hex 10-32 Z 2 ea.
002-161 Flat washer #10 5 ea.
005-131 Screw 10-24 x 1/2 - stainless 6 ea.
005-132 Nut hex 10-24 - stainless 6 ea.
005-155 Screw 10-32 x 3/8 - black 2 ea.
008-244 Acorn nut 1/4-20 - nickle 2 ea.
10A Handle 1 ea.
1000132 Hinge 2 ea.
1000252 Cotter pin 1 ea.
1000652 Clevis pin 1/4 dia. 1 ea.
1002423 Owner's Manual 1 ea.
1002656 Flat washer #10 - nylon 6 ea.
11130 Slotted plug - nylon 1 ea.
11957 Actuator 1 ea.
12131 Actuator bracket 1 ea.
53B Stem support female 1 ea.
83 Hex bolt 1/4-20 x 1 - zinc 2 ea.
84 Hex nut 1/4-20 - zinc 2 ea.
85 Lock washer 1/4" 4 ea.
C9A Nipple 1/8 NPT x 4-1/2 1 ea.
NOTE: Dimensions listed are overall measurements.
M5
Tube 5/32 blue plastic 27 in.
M5-BLACK Tube 5/32 black plastic 9in.
M5-NEUTRAL Tube 5/32 clear plastic 11 in.
M230-002 Knob for timer 1 ea.
M230-005 S
p
acer 1/8" thick - n
y
lon 1 ea.
Model Information
A
B
C
D
Parts bag contents
30 005
Space /8 t c y o
ea
A
BCD
One gun, one cup paint gun washer equipped
35.625 16.75 22.5 20.375
with diaphragm pump, filter-regulator and timer.
(905) (425.5) (571.5) (517.5)
Capable of cleaning solvent and water base paints.
Installing the Gun Washe
r
1) Place gun washer on a level surface in a properly
ventilated paint mixing room or paint booth.
Grounding the Gun Washe
r
1) Connect the ground wire on the gun washer’s pump to a
true earth ground.
2) Ground all equipment used or located in the gun washer
area.
Connecting the Air Line
1) Install a 1/4 in. npt male coupler, that is compatible with
the quick disconnect of your air supply line, into the air-in
port of the filter/regulator located on the right rear leg
(see fig.9).
2) Connect air line with at least 75 psi to the coupler.
Filter/regulator is preset. Do not adjust.
DescriptionModel
Installation
20.2
Dimensions (in/mm)
44.5
Weight
(lbs/kg)
G100
A
B
C
D
Air in port
fig.9
Ground
Parts bag contents
Page 8 of 19