Installation manual

Level

Stud

Power Drill

Screw Ezy-Mount on the

wall with 3 x screws;

make sure it is level.

You can slide screen sideways until it lines up

with the image horizontally. Make sure

projector sits perpendicular to the screen.

Happy Viewing!

Tilt Screen

15°

Hook screen onto

top edge on

ezy-mount 15° from

vertical then let it

drop into position.

Image Area

33mm

2C Frame Screen

Installation Manual

For more information please go to

www.2cdisplays.com.au

or call 1300 730 025

Mar 2009 v2.1

PAGE 1
6 Stud Level Screw Ezy-Mount on the wall with 3 x screws; make sure it is level. Im ag eA rea 33mm Power Drill 1 Tilt Screen 7 2 Hook screen onto top edge on ezy-mount 15° from vertical then let it drop into position. 15° 8 You can slide screen sideways until it lines up with the image horizontally. Make sure projector sits perpendicular to the screen. Happy Viewing! For more information please go to www.2cdisplays.com.au or call 1300 730 025 Mar 2009 v2.
PAGE 2
Required (not supplied) Level Electric drill Screw Driver 1 See detail on frame assembly below Lay each section of the frame face down as shown. Insert both short frame sections into the long frame sections with corner stakes. Ensure all joints are square and then lock off by tightening the grub screws.