User Guide

HermanMiller Mirra

2 Chair Adjustment Guide1

HermanMiller

Mirra

2 Chair

To raise:

Take your weight o chair, li tab up.

To lower:

Li tab up while seated.

At the proper height, your feet should rest flat on the floor with upper and

lower leg forming a 90 degree angle.

Seat Height: Lower right side of seat

To adjust:

Squeeze handle and adjust seat edge

up or down. Release handle to lock in

position.

In the proper position, you will have a minimum of three-ngers of clearance

between the back of your knees and the front seat edge.

FlexFront

Seat Depth: Handle under front of seat

To increase:

Turn knob clockwise.

To decrease:

Turn knob counterclockwise.

Set the tilt tension to control the resistance you feel when reclining.

Harmonic

™

Tilt Tension: Knob below right front side of seat

To engage:

Recline and flip lever down.

To release:

Recline and flip lever up.

Engage forward tilt to support the thigh’s declined posture when performing

intensive tasks, such as keyboarding.

Note: When using forward seat angle, increase seat height slightly for

added comfort.

Forward Tilt: Horizontal tab on le front side of seat

Only available on some models.

PAGE 1
HermanMiller Mirra 2 Chair ® Seat Height: Lower right side of seat FlexFront Seat Depth: Handle under front of seat ® To raise: Take your weight off chair, lift tab up. To adjust: Squeeze handle and adjust seat edge up or down. Release handle to lock in position. To lower: Lift tab up while seated. In the proper position, you will have a minimum of three-fingers of clearance between the back of your knees and the front seat edge.
PAGE 2
Tilt Limiter: Vertical tab on left front side of seat Lumbar Height & Depth: Levers on lumbar support Only available on some models. Only available on some models. To engage: Recline and move lever up to define the limit of recline. To adjust height: Rotate levers to loosen, slide lumbar support up or down to desired height. To release: Lean forward and press lever back. To increase depth: Rotate levers downward. To decrease depth: Rotate levers upward.