User Manual

HERMOS AG
Gartenstraße 19 • 95490 Mistelgau
Phone: [phone] - 0
E-mail: [e-mail]
LFM 4x Reader Rev1.4
back to the table of contents
64
www.hermos.com
Customer manual
LFM 4x Reader
RFID
WE GENERATE SOLUTIONS
10.5 Parameter
The parameters 0, 1, 2 and 7 are only valid if the reader is equipped
with a corresponding I / O module and provides one input per antenna
port.
*): Since software revision V1.5 some parameters are implemented
for each antenna port. Addressing of the parameter takes place via
the reader ID of the message. In this realisation, the parameter is
present once per antenna port. If no parameter arrays should be
used, please ask the manufacturer (parameter 63)!
The data element „Parameter No.“ can have the following values. List of public paramters:
Nr.
(dez)
Nr.
(hex)
Parameter
name
Description
0
0x00
Sensor delay
Delay time for the presence sensor.
01 .. 99 (0,1 Sekunden)
Default: 10 … (1 second)
Realisation: a separate parameter for each port *)
1
0x01
Read mode
Read mode for reading automatically started by external
input. 00 - read only one page
01 - read until the end character or empty
character2) 02 - read all pages
10 - read only one page with previous sensor Check1)
11 - read until the end character / empty character
with previous sensor check 1) 2)
12 - read all pages with previous sensor
Check1) 99 - Disable sensor
1) If the Sensor Check (first byte = 1) is activated, the assignment of
the potential-free input is checked before initiating a read / write
process. When used, the read / write process is started, otherwise the
error message „NOTAG“ is sent.
2) ‚E‘ or ‚F‘ in ID bits 0...3 of the read ID
Default: 00 … (read only one page)
Realisation: a separate parameter for each port *)
2
0x02
Read page
Page for readmode „00“.
01 First page of each transponder
02.. 17 Side of a multipage
transponder Default: 01 (read first
page)
Realisation: a separate parameter for each port *)
3
0x03
r/w repeat
time
Time between two read / write attempts.
01 .. 99 (0,1 s)
Default: 05 … (0,5 seconds)
Realisation: a separate parameter for each port *)