User Manual

Customer manual
LFM 4x Reader
RFID
WE GENERATE SOLUTIONS
HERMOS AG
Gartenstraße 19 • 95490 Mistelgau
Phone: [phone] - 0
E-mail: [e-mail]
LFM 4x Reader Rev1.3
back to the table of contents
84
www.hermos.com
SHEAD Format: B[10]
Information about the condition of up to two sensors and the initiator of the message.
Initiator Bit0 ….Bit 4:
The initiator sets the number of the sensor that triggered the message.
1 … 4 port1 to port4
Sensorstate Bit5 ….Bit 7:
The current state of the sensor is described with 3 bits.
0 … Sensor is not occupied
1 … Sensor is occupied or detected
7 … Sensor not defined
Example: 0x24 means Sensor ist deteced (0x20) and the initiator was sensor at port4 (0x04)
Where used S3F5, S3F7, S3F13
Information about the operating mode
„NE“ … normal execution
„MR“ … operating mode „maintenance“ required
Where used S18F2, S18F4, S18F8, S18F10, S18F12, S18F14
Confirmation code reset
0 … Reset could be executed
1 … Reset could not be executed
Where used S18F20
1 … Power-up-Reset
2 … Software reset (without reset of the Ethernet component)
Where used S2F19
Head of the stored SECS message block. Only the last message is saved. This must be confirmed by
the host.
Where used S9F9
RAC Format: B[1]
PTN Format: B[1]
PM Information Format: A[2]
RIC Format: B[1]