Owner's Manual

H8 DSP
Digital Interface Processor
User’s manual
1
1
2
8
3
5
9
4
11
6
7
10
2
1
2
3
4
5
6
7
8
9
10
12
11
8
30
This window indicates whether the H8 DSP is correctly connected to the PC and the DRC. It also shows the device
Firmware version.
When the File tab is selected a drop-down menu will appear
including the entries shown in the image:
8.4 DEVICE INFO
8.3 ADJUSTING ACOUSTIC REPRODUCTION
1. Load Setup: Load Setup: the entire H8 DSP configuration is loaded from
a previously saved file (e.g. “H8Config.dip”).
This feature is available both in TARGET and in OFFLINE mode. In TARGET mode,
it can be used to load all the settings that have been previously saved.
This is useful if you want to resume all the settings you previously selected
to install another H8 DSP with the same settings.
Output levels calibration and de-equalization, if any, must be repeated.
In OFFLINE mode, it can be used to check the features you previously saved.
8.5 “FILE” MAIN MENU
The following chapters detail the system adjustments and acoustic tuning features.
WARNING: We recommend that you do not modify the settings of your H8 DSP to explore its features.
Take your time to get familiar with the possibilities this software offers.
If you decide to leave the amplifiers connected to the H8 DSP, remember to perform the adjustments
keeping the general volume at a level that does not damage the speakers in your system.