Specification Sheet

Elettromedia - 62018 Potenza Picena (MC) Italy - T [phone] - F [phone] - www.elettromedia.it
All Specifications Subject to Change Without Notice_15.A
18
A 165 mm 6.5 in.
B 141 mm 5.55 in.
C 74 mm 2.91 in.
D 62,6 mm 2.46 in.
E 183,5 mm 7.22 in.
F 29 mm 1.14 in.
MPX 165.3
COAX
200 W
ELECTRO-ACOUSTIC PARAMETERS
D mm 132
Xmax mm ±3
Re Ω 3,1
Fs Hz 90
Le mH 0,01
Vas I 4
Mms g 18,9
Cms mm/N 0,15
BL
T•m
5,8
Qts 0,88
Qes 1,06
Qms 5,5
Spl dB 92
TECHNICAL SPECIFICATION
Component Two way coaxial
Size
Woofer mm (in.) 165 (6.5)
Tweeter diaphragm mm (in.) 25 (1)
Voice Coil Ø
Woofer mm (in.) 36 (1.42)
Tweeter mm (in.) 20 (0.8)
Power Handling
W peak 200
W continuos 100
Impedance Ω 4
Frequence Response Hz 45 ÷ 21,5k
Crossover Integrated 3.5 kHz @ 6dB Oct.
Woofer Magnet size
D x d x h
mm
(in.)
90 x 45 x 17
(3.54 x 1.77 x 0.67)
Tweeter Magnet size
D x d x h
mm
(in.)
29.5 x 22 x 4
(1.16 x 0.87 x 0.16)
Weight of one speaker kg (lb.) 1.27 (2.8)
Woofer Magnet High density flux ferrite
Tweeter Magnet Neodymium
Cone Pressed-pulp cone with cotton fibers
Dome Tetolon
Xmech mm (in.) ±6 (0.24)
1. Concentric coaxial tweeter built in the woofer voice coil, achieving one single
point of emission, to re-create the virtual sound-stage like in live music
performances.
2. 20 mm voice coil Tetolon fiber soft dome tweeter, featuring “Center Tuning
Duct” geometry, for lower resonance frequency and reduced harmonic
distortion.
3. Tweeter support working as a rear chamber, sized for low Fs, to ensure a well
damped high pass frequency roll-off, allowing low cut-off frequency
crossover point.
4. 36 mm pure copper woofer voice coil wound on a Polyamide former, for
outstanding power handling and dynamic compression-free reproduction.
5. Pressed-pulp cone with cotton fibers, combining stiffness and lightweight
for a wide frequency response. Cone profile geometrically refined to
perfectly match with the tweeter emission ensuring phase consistency in
the crossover area.
6. “Boundary Free” rubber surround, for improved efficiency and wider
mid-bass frequency.
7. Over-sized ferrite magnet combined with very low carbon content iron
plates, for low distortion at high power levels.
8. Low mounting depth, acoustically transparent aluminium alloy basket with
elegant diamond cutting and featuring the aluminium Hertz logo.
9. Anti-vibration rubber magnet cover, to damp spurious vibrations.
A
C
B
D
F
E
Optional