Owner's Manual

34
USER’S MANUAL /
MIXER:
It is possible to assign the mixing percentages of the inputs in two ways: (Auto/Man).
It is possible to switch from the Mixer Auto mode (default), to the Mixer Man mode and vice versa clicking on
the Auto or Man keys, upon clicking a warning pop up will appear on the screen.
Auto, (Default) The software will calculate, based on the selected inputs, a percentage of equal value in order to
reach 100% of the signal at the assigned output.
Man, it is possible to manually operate on the mixing percentages, assigning the desired value to each input
and confirming it with
E.g. if you want to reconstruct a full range signal from a source with filtered outputs, each input can be set to
100% in order to obtain a Full range output signal without distortion.
E.g. If only one input is associated with an output, the
software will set it to 100% (fig 1), while if several inputs
are associated with a mono output (Eg. Subwoofer or
Center), the software will set them in equal percentage
(50% / 50%) so that their sum is 100%. (fig 2).
Fig. 1
Fig. 2
%
100 1K 10K
0
100
- select “Don’t ask again in this session” to stop showing this pop up in this work session.
- press OK to switch mode.
- press Cancel to cancel the operation.
Switching from Mixer Auto mode to Mixer Man mode
IN 2
OUT
IN 3IN 1
7
4